4-Jaw Flange Chucks
3-Jaw Flange Chucks
Frequently Asked Questions
Oneida Double Angle Collet Chucks
|Double angle means twice the grip|
|Collet design runs solid steel |
|Unmatched performance |
when used in balancing slip yokes.
|Collet opens .030" to load, |
will not scratch part
|Tapered fits eliminate any wear & run out|
|Chucks can accommodate |
a range of collets.
|Supplied with splined anti-rotate shaft, |
or can be made thru hole.
|Spring loaded, safely holds without power. |
|Could be used on a machining center pallet.|
|Even, firm pressure will not pinch |
thin walled parts as 3-jaw chucks do.
|Air, hydraulic, pull, or push to release.|
|Does not require operator to "tap" collet |
to release. Collet "pops"
out of taper.
|Adapts to any spindle.|
|No exposed joints|
||1 1/4" - 2 1/16"
||1 5/8" - 2 3/4"
1 3/4" - 4"